GCP Applied Technologies

JUNE 7, 2018

Waterproofing Membranes for Below Grade Structures. Waterproofing Membranes for Below Grade Structures. Waterproofing Below Grade Structures. Specifying Below Grade Waterproofing. Water is under pressure below ground and forces its way through even the smallest cracks in the concrete. Waterproof concrete.

Waterproofing Systems 103

Waterproofing Systems Concrete Pouring Structural Systems Foundation Systems 103

CivilJungle

OCTOBER 23, 2021

The sunken slab is one of the familiar and adaptable ways to maintain architectural design in especially the washroom, as well as laundry areas where water drainage systems or pipes installed below the floor or tiles. This system is accepted to provide an easy way to install sanitary products and built eye-catching views in those areas.

Concrete Pouring 52

Concrete Pouring Waterproofing Systems Piping Installation Plumbing Systems 52

CivilJungle

MAY 24, 2021

What Is Concrete Topping? A Concrete topping is a process of laying out a layer of high strength concrete on the old worn-out layer of the concrete. It is nothing but placing a layer of concrete over the existing slab in order to give a finished floor surface on the old layer of concrete.

Concrete Pouring 84

Concrete Pouring Flooring Systems Plumbing Systems Curing 84

CivilJungle

FEBRUARY 5, 2022

In this article, we will discuss all about the concrete masonry units. The CMU wall is constructed with the help of standard sizes concrete masonry units. A concrete masonry unit (CMU)is a versatile and environment-friendly building unit that is available in a variety of shapes and sizes in the market. Concrete Bricks.

Masonry 52

Masonry Concrete Pouring Wall Systems Building Materials Manufacturing 52

CivilJungle

APRIL 22, 2022

What to Do If the Concrete Cube Fails After 28 Days? So, What To Do If Concrete Cube Falls after 24 days? There are many record and recovery choices if the concrete cell falls in the Test. There are many record and recovery choices if the concrete cell falls in the Test. Cube Test of Concrete.

Concrete Pouring 52

Concrete Pouring Curing Structural Systems Staircases 52

Construction Specifier

JUNE 20, 2024

1 The only exception noted in the code is for a coal tar based roof system. A sloped water-shedding roof can tolerate some minor imperfections during construction and still perform its primary function for waterproofing. Conversion factors are provided for International System of Units (SI). Section 1105.2 Section 1106.1

Roofing Systems 59

Roofing Systems Piping Installation Concrete Pouring Wall Systems 59

Construction Specifier

JUNE 20, 2024

1 The only exception noted in the code is for a coal tar based roof system. A sloped water-shedding roof can tolerate some minor imperfections during construction and still perform its primary function for waterproofing. Conversion factors are provided for International System of Units (SI). Section 1105.2 Section 1106.1

Roofing Systems 52

Roofing Systems Piping Installation Concrete Pouring Wall Systems 52

CivilJungle

FEBRUARY 21, 2021

Formwork is the mould used during the building to give the desired structural form by pressing concrete into the mould. In a single term, formwork is a mould that cast concrete in various shapes and sizes. Designers will also have to extract the shape until the concrete has achieved the required power. Plain concrete shape.

Concrete Pouring 52

Concrete Pouring Steel Fabrication Building Materials Manufacturing Building Materials 52

CivilJungle

NOVEMBER 19, 2020

In building construction, the first stage is earth excavation , which is then followed by dewatering the trenches, laying of brick flat sloping and PCC layer, placing of reinforcement caging for the construction of footings, and finally the Concreting of foundations. Adhesive resins such as bitumen, tar, natural gum, wax etc.

Building Materials Manufacturing 52

Building Materials Manufacturing Waterproofing Systems Concrete Pouring Building Materials 52