Concrete Pouring Plumbing Systems Waterproofing Systems 
CivilJungle
MAY 24, 2021
What Is Concrete Topping? A Concrete topping is a process of laying out a layer of high strength concrete on the old worn-out layer of the concrete. It is nothing but placing a layer of concrete over the existing slab in order to give a finished floor surface on the old layer of concrete.
CivilJungle
OCTOBER 23, 2021
The sunken slab is one of the familiar and adaptable ways to maintain architectural design in especially the washroom, as well as laundry areas where water drainage systems or pipes installed below the floor or tiles. This system is accepted to provide an easy way to install sanitary products and built eye-catching views in those areas.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.
CivilJungle
OCTOBER 18, 2021
Then after architect consult with a structural engineer and MEP engineer for details of the reinforcements and other detail for use, how deep your foundation will be, the size of gravel to be used, column width, electrical, plumbing, etc. Also, read: IS 516:1959 Most Important Point (Method of Tests For Strength of Concrete).
CivilJungle
FEBRUARY 4, 2021
The lateral and gravity load resistance system in this system consists of reinforced concrete walls and slabs of reinforced concrete. The key vertical structural elements are reinforced concrete structural walls with a dual function in resisting both the gravity and lateral loads.
CivilJungle
DECEMBER 25, 2021
Water can be the most destructive element for structures that are mainly constructed from concrete. The water leakage problems are due to various issues such as defective plumbing systems. If the faces of the walls are exposed to the rain and it is not properly protected and waterproofing is done. Roof Water Leakage.
Construction Specifier
JUNE 20, 2024
1 The only exception noted in the code is for a coal tar based roof system. A sloped water-shedding roof can tolerate some minor imperfections during construction and still perform its primary function for waterproofing. The 2018 International Plumbing Code ( IPC ) Section 1101.7 Section 1105.2 Section 1106.1 1) through 1106.1(5)
CivilJungle
NOVEMBER 19, 2020
In building construction, the first stage is earth excavation , which is then followed by dewatering the trenches, laying of brick flat sloping and PCC layer, placing of reinforcement caging for the construction of footings, and finally the Concreting of foundations. Adhesive resins such as bitumen, tar, natural gum, wax etc.
Expert insights. Personalized for you.
84 
Let's personalize your content